The fuselage and screen have about 2 to 3 mm gaps. How do you get it back? Be useful and don't break into the main part.
Welcome Guest.
The fuselage and screen have about 2 to 3 mm gaps. How do you get it back? Be useful and don't break into the main part.
+4Votes
1, of course, the whole machine is completely disassembled, and the corresponding screwdriver should be prepared before use.
2, when removing the screen, pay attention to gently separate the small chip connected to the motherboard from the motherboard.
3. Before removing the metal shielding isolation layer, tear off the card slot sticker under the network access card and the network access card.
4, the last is to blow dry hair dryer, but do not blow on the screen for a long time, such high temperature will destroy the screen, even if the screen has a watermark, you can use the phone normally, the screen Water will usually dry in two days, and you will see the watermark inside it getting smaller and smaller.
5. Blow the front and back of the main board to ensure that there is no residual moisture. The earpiece and button should be blown out as much as possible.
6, Finally, put the disassembled mobile phone in a dry place, preferably about two days, and then install it.
+8Votes
It’s best to go after-sales service
+1Votes
Go to after-sales, you have to install a screen glue yourself
+3Votes
After the sale, he will give you a good job
+7Votes
To the store to see
+5Votes
Need to go after-sales service!
+6Votes
It is best to send the store to the maintenance staff to repair, do not do it yourself.
+5Votes
This is best to go to the mobile phone store, let the maintenance staff help you get
+5Votes
to the repair center to check the possible battery expansion relationship .
+7Votes
Pro, if the screen is detached, the personal suggestion is to remove the machine and reinstall it. Don’t just press it back and avoid hardware damage,
If you are not familiar with it If you disassemble the process, it is recommended to go to the after-sales or mobile phone shop for help, so as to avoid accidents and cause more damage. Please refer to it,
+1Votes
or go to Huawei’s after-sales service department to repair it.
+1Votes
With 502 glue, the battery may be drummed.
+1Votes
If you don’t have the ability to do it yourself, just look for a mobile phone repair and let people install it. go back. Can’t spend two money
+6Votes
Go to Huawei for after-sales service, and there are suggestions that Huawei will either buy a flagship model or change the brand. The low-end Huawei is very general
+3Votes
You can only take the mobile phone shop
+6Votes
to get the after-sales to deal with, if the memory is really full, no need to deal with it,
+3Votes
This phone is still thrown…. ..
+3Votes
It is recommended to call Huawei customer service phone
Customer service hotline 400-830-8300
Consult.
+6Votes
Need to align the buckles or find customer service after sales