Welcome Guest.

13Answers

Solve; this prompt appears after inserting a USB flash drive

Asked by: Diane 242 views Hardware June 26, 2019

Normally insert the USB port on the front panel of the chassis, the same situation occurs in both ports

Click "Reset" and the following picture appears, enter the infinite loop

Solve, what to do, how to Office

13 Answers

  1. +4Votes  

    Try the USB3.0 interface

    Question: I inserted 3.0! ! ! ! !

    Answer: Your U disk may be a non-standard USB 2.0, and then try a small device with USB-HUB.

    Gary- June 26, 2019 |

  2. +7Votes  

    Change a socket, don’t try another computer, in this case, even if other computers can be used away from the bad

    Question: No. Don’t scare me

    James Lewis- June 26, 2019 |

  3. +1Votes  

    Power surge is a short-lived phenomenon of strong current and voltage fluctuations. This fault indicates that a high-power USB device is connected to the computer. Win10 system often reports this. Wrong, open the USB in the device settings, and if you turn off the option when you connect to the USB device, you will not get an error.

    Susan Anderson- June 26, 2019 |

  4. +7Votes  

    Change the computer and if so, then the manual U Disk problem

    Richard- June 27, 2019 |

  5. +3Votes  

    This is obviously caused by damage to your USB flash drive

    Question: What the hell, I will Just insert the front of it, there is no problem after plugging

    Question: I have no problem with U disk

    Brian Hughes- June 27, 2019 |

  6. +5Votes  

    Try a USB interface

    Ann- June 27, 2019 |

  7. +3Votes  

    Computer internal Line problem or motherboard front USB problem

    Joseph- June 27, 2019 |

  8. +4Votes  

    The voltage at the front of the computer is unstable, plug in the back of the computer

    Virginia Lewis- June 27, 2019 |

  9. +2Votes  

    USB interface is powered up Inserting the contact piece to oxidize, Insufficient power

    Gary Anderson- June 27, 2019 |

  10. +3Votes  

    Try to insert the rear USB interface

    Question: No problem after plugging

    Deborah Lee- June 27, 2019 |

  11. +7Votes  

    The front panel USB port is not fully powered

    Question: Impossible, just plug in a USB flash drive, before it is OK

    Joyce Evans- June 27, 2019 |

  12. +3Votes  

    You try to plug it into the USB port on the back of the chassis. If it doesn’t work, then use 360. Security guard’s Lu master detection and repair to see

    Question: The following is OK, just like this, how to do

    Margaret- June 27, 2019 |

  13. +4Votes  

    u disk does not drive ~ and you u The disk is usb3.0~ It is best to plug into the 3.0 interface

    Question: Are you oh, I am not plugged in port 3.0

    Answer: Halo ~Your picture is clear, isn’t it? Are you asking questions to live?

    Question: The driver is fine, what should I do, just the front is no problem, just what, this is the problem. What to do

    Carolyn Clarke- June 27, 2019 |