Welcome Guest.

2Answers

Solidworks2015 can’t use the sketch command when entering the sketching interface, and what is the special card?

Asked by: Diane Wood 197 views Software August 8, 2018

The first picture is to enter the sketch interface using the rectangle command, you can't select the center point, and just drag the data in the left information, but there is no rectangle in the plane, then I just draw a few The rectangle, the second one is the view of the rotated view, the previously drawn rectangle is there, but the sketch interface can not be seen at all, and can not select the center point painting, but also special card. I have uninstalled and reinstalled several times. What is the situation?

2 Answers

  1. +2Votes  

    System Options→Sketch→Geometry/Capture→Activate Capture. It’s OK.

     

    Patrick Scott- August 9, 2018 |

  2. +8Votes  

    Send the computer configuration to see? It is possible that the graphics card is too low or the driver is too old.

    Enter system options, performance, try to reduce the display accuracy.

    As for selecting points, go to System Options – Sketch – Geometry / Capture and check the center point.

    Question: The computer configuration should not be low, it is ok, there is no problem running Pro, the problem of selecting the point is because it has already been The reason for checking is still like this.

    Brian Ward- August 9, 2018 |