Welcome Guest.

11Answers

The bios handcuffs turned off the things related to the graphics card the computer can’t be turned on now the display has no signal.

Asked by: Ronald 206 views Computer October 19, 2018

Rt Is there still a way to solve it?

Addition: The motherboard is Jiewei's

Addition: The host light is on but the display has no signal

Addition: The graphics card is built-in with no other integration.

11 Answers

  1. +5Votes  

    Turn on the button and press “del” (some computers are F2) to reset the BIOS

    Answer: Can’t buckle the motherboard battery

    Answer: Then the positive and negative Short-circuit, then install the battery, BIOS can restore the factory settings

    Answer: Press “del” can not enter, then open the chassis to remove the motherboard battery

    Angela- October 19, 2018 |

  2. +6Votes  

    motherboard BIOS put a Power, restore the initial state. There are two ways to discharge. One is to find the CLS CMOS jumper around the battery on the motherboard. It is just a short circuit, and the power is removed. The battery is buckled down for a few minutes and then loaded back.

    Elizabeth Wood- October 19, 2018 |

  3. +1Votes  

    Reinstall the system.

    Virginia Phillips- October 19, 2018 |

  4. +7Votes  

    The motherboard jumper will be shorted. If you don’t, you can put the battery down for a while, or directly short the two electric shocks.

    Shirley Turner- October 19, 2018 |

  5. +8Votes  

    Re-plug the memory

    Patricia Lee- October 20, 2018 |

  6. +2Votes  

    If it is a BIOS setting problem, you can use the jumper to clear the settings. I hope you are satisfied! ! !

    Jackson- October 20, 2018 |

  7. +7Votes  

    It is not a BIOS problem, memory contact is not good.

    Ronald Morris- October 20, 2018 |

  8. +8Votes  

    One-click restore system function

    Jason Walker- October 21, 2018 |

  9. +6Votes  

    Please use one-click to restore system features or reinstall system features with 360.

    John Williams- October 22, 2018 |

  10. +5Votes  

    Remove the motherboard battery and restore the motherboard to factory settings.

    Susan Evans- October 23, 2018 |

  11. +7Votes  

    The machine was removed, the motherboard battery was deducted, the jumper was discharged, and then the factory settings were restored.

    Jerry Jackson- October 23, 2018 |